These axle shafts are to fit a SCX10.1 or AX10 axle when doing the XR narrow or the XR wide mod.

You will need a knuckle that works with the stub shaft you choose. Either a Wraith style or 8mm stub shaft.

If using Wraith style stub shafts, anything that works with Wraith, Bomber, XR10 etc,. will work. You will also need to run C hubs that work with this knuckle.

If using 8mm style stub shafts, you will need Dlux 8mm knuckles and then you can use either the stock C hubs or Wraith style C hubs, like described above.

Made from heated-treated chromoly (XR-wide), or zinc-plated 4340 (XR narrow) for strength and durability

These universal shafts are capable of approx 70* of steering. YOU MUST RUN MECHANICAL STEERING STOPS WHEN RUNNING THESE SHAFTS OR YOU WILL HAVE INSTANT BREAKAGE!

The tangs on the shaft are a hair bigger than stock Axial tangs. Depending on your locker situation, you may need to file the flat of the tang to fit in your locker.

Please check this thread for all information on these shafts:

http://www.rccrawler.com/forum/axles-trannys-t-cas...

With each purchase you will get:
2- axle shafts with either 8mm stub shafts or Axial stub shafts.

Some