See our Facebook page for more details on the Madhouse giveaway!
Link Riser for Traxxas TRX4
SKU 00353
$9.99
Tall or Short
In stock
1
Save this product for later
Link Riser for Traxxas TRX4
Product Details
Traxxas TRX-4 Link Riser. These fit Traxxas 82010-4, 82024-4, 82046-4, 82076-4, 82034-4, 82096-4, or any TRX4.
This is a link riser to raise your rear upper links. Fits all Axial AR44 housings (does not fit SSD housings). This part will provide better anti-squat geometry to hold the front end down while climbing to improve hill climbing ability. Also gives a reduced turning radius and helps a little bit with torque twist. 2 positions so you can decide how little or how much additional anti-squat you want. The difference is very noticeable immediately after installing this part. Trust me, just do a before and after turning radius test. Most, if not all of the competition guys run rear link risers. Some even use them in the front. They will fit the front axle, but I recommend using them only in the rear.
This is a single link riser with hardware. Enough to do one TRX4 Portal Axle.
These are 3d printed from carbon fiber infused Nylon. Very strong and the fitment is fabulous. Absolutely no wiggle even before the bolt is tight.
***Fitment note: For the tall link riser it is made for ultimate performance. Typically for competition use. It will require significant modification to the shock mount and battery tray, possibly more depending on which TRX4 you have. It's well worth it.***
***Fitment note: For the short link riser it will slightly limit rear suspension uptravel, or require trimming of the rear shock tower. It's well worth it.***
***axle housings and related parts shown in the photo are not included*** They were used to illustrate a typical installation and show off how nice they look when installed.
This is a single link riser with hardware. Enough to do one TRX4 Portal Axle.
