7mm FBA REAR AR60 type Axle shafts

Now with a 2yr warranty***!!!

Rear axle shafts made from carbon steel. These shafts are giant 7mm in diameter with 8mm stub shafts. I don't think you will be bending a stub shaft with these again!

Comes with:
Axle shafts
Bearings
Wheel hubs
Locker
Hex pins
Ring and pinion

You MUST use an aluminum housing to run these axles.

You MUST drill out the axle tube to fit these. The shafts measure approx .275" diameter so something like a 9/32" (.281) will work great if you're accurate enough or you might have to go bigger if you're not accurate.

If you're running a Currie style or SSD axle, you will need to bore out the ends of the tubes so the new MONSTER bearings can fit.

If you want to send me your axles, I can have these fully assembled for you or I can just do the machining to make the parts work and you can assemble them.

Yeti rear axles will want the 600 size hub to be wide enough for the front.

The locker is tight on the non ring gear side. You will need to lightly tap in the shaft from that side.

Hubs are threaded for M3. If you use a wheel that uses a 4-40 thread, you will need some scale hardware so they will fit. I use these:https://lockeduprc.3dcartstores.com/M3-x-10mm-Scal...

Hub sizes are approx:
0 offset stainless approx 9.775"
225 offset approx 10.375"
350 offset approx 10.625"
475 offset approx 10.875"
600 offset approx 11.125"

Super shafty housings:

https://supershafty.com/collections/axles-mods/pro...

Simple install. See video for more info

***Warranty valid for 2 years from original purchase date. Original purchaser only, non-transferrable. Warranty coverage includes locker and shafts. Ring and Pinion, bearings, snap rings, housings, etc... are not covered under warranty. Warranty does not include shipping cost. You must send parts to me for repair or replacement, and pay for return shipping.