These axle shafts are to fit a Wraith/Bomber or AR60 axle.

If using Wraith style stub shafts, anything that works with Wraith, Bomber, XR10 etc,. will work.

If using 8mm style stub shafts, you will need Dlux 8mm knuckles

Made from heat treated chromoly, the shafts will come with either the stock Axial stub (Wraith/XR style) or the 8mm stub version. You will need knuckles to match the stub shaft. If youre running the Axial version, either a XR or Wraith knuckle is needed. If youre running the 8mm stub version, you will need knuckles that accommodate 8mm stub shafts (such as the Dlux knuckles).

These universal shafts are capable of approx 70* of steering. YOU MUST RUN MECHANICAL STEERING STOPS WHEN RUNNING THESE SHAFTS OR YOU WILL HAVE INSTANT BREAKAGE!

The tangs on the shaft are a hair bigger than stock Axial tangs. Depending on your locker situation, you may need to file the flat of the tang to fit in your locker.

Please check this thread for all information on these shafts:

http://www.rccrawler.com/forum/axles-trannys-t-cas...

With each purchase you will get:
2- axle shafts with either 8mm stub shafts or Axial stub shafts.