Dlux S2 ESC
SKU 51061
$110.00
Battery Connection
In stock
1
Save this product for later
Dlux S2 ESC
Product Details
AM32 firmware for the quietest, smoothest control of non-sensored brushless motors
70 Amp continuous / 110A burst current rating. Rated for up to 8S (8 Cell, 33.6 Volt) batteries, 3S(12.6V) or 4S (16.8V) recommended. Note: Be sure to check your servo specifications for recommended maximum operating voltage.
Perfect for outrunner motors, or any non-sensored brushless motor.
Fully programmable. USB programmer is included! Works for most AM32 ESC's.
Includes integrated 5A BEC set to 7.4 volts (non-adjustable). Note: High power 3 wire servos will require an external BEC.
Includes JST connector for direct power servo or BEC.
Includes 4mm bullet connectors for motor.
Includes either XT30, XT60, or Deans battery connector.
Heat sink can be removed for weight savings.
In-house conformal coated with premium materials for the ultimate in water resistance.
Not intended for brushed motors.
Requires:
PC or Laptop, programming software, and USB to Type C adapter cable capable of data transmission (not just charging batteries).
Download your software here:
https://drive.google.com/file/d/1qw2f7nM6OZftIE5GTgMPWB5zXCELxYG9/view
Device drivers can be found here:
https://www.silabs.com/developers/usb-to-uart-bridge-vcp-drivers
***We cannot provide technical support, programming assistance, or instructions for this product. There is great information on Facebook, please take your time and search thoroughly.***
**External TVS diode recommended for direct power servos on 4s power, consult your servo manufacturer for more information**
You May Also Like
Powered by Lightspeed
Display prices in:USD
